MITCalc - Rolling Bearings Calculation 

Selection, calculation and check of rolling bearings of the company SKF. Application supports Imperial and Metric units, is based on SKF, ISO, ANSI, SAE standards and support many 2D and 3D CAD systems
bearings bearing roller bearing bearings pair basic dynamic load equivalent dynamic load basic life basic static load equivalent static load static safety factor permissible radial load permissible axial load reference speed.

MITCalc - Bevel Gear Calculation 

Geometric design and strength check of bevel gear with straight and helical toothing. Application supports Imperial and Metric units, is based on ANSI/AGMA and ISO/DIN standards and support many 2D and 3D CAD systems
gearing bevel gear gear tooth toothing design strength check helical din 3971 din 3991 iso 6336 iso 1328 din 3990 ansi b6.1-1968

MITCalc - Tolerance analysis 

Two programs for the tolerance analysis of linear, 2D and 3D dimensional chains (Worst case, Root Sum Squares, Monte Carlo...). Application is developed in MS Excel, is multi-language and supports Imperial and Metric units.
tolerance tolerances analysis worst case root sum squares 6 sigma deviation fits ansi b4.1 ansi b4.2 iso 286 iso 1829 iso 2768 en 20286

MITCalc - Timing Belts Calculation 

Geometric design and strength check of toothed belt transmissions. Application contain a database of timing belts, supports Imperial and Metric units, is based on ANSI, RMA, ISO, DIN and BS standards and support many 2D and 3D CAD systems.
belt toothed belt timing belt synchronous belt design strength check ansi/rma ip-24 1983 din 7721 din iso 5296 iso 5295 iso 5294

MITCalc - Spur Gear Calculation 

Geometric design and strength check of spur gear with straight and helical toothing. Application supports Imperial and Metric units, is based on ANSI/AGMA and ISO/DIN standards and support many 2D and 3D CAD systems
gearing spur gearing gear tooth toothing design strength check helical iso 6336 iso 1328 din 3990 ansi b6.1-1968 agma 2001-c95 agma 908-b89/95

MITCalc - Shafts Calculation 

The calculation is designed for geometrical design and complex strength check of shafts. Application supports Imperial and Metric units, is based on ANSI, ISO, DIN standards and support many 2D and 3D CAD systems
shaft shafts design strength check stress concentration critical speed safety coefficients deflection bending angle din 743